Dominant Loading in 5- to 30-Story Reinforced Concrete Frame Buildings and Its Influence on Structural Member Sizing

Authors

  • Irhad Mrkonja Author
  • Ahmed El Sayed Author
  • Sanin Džidić Author

DOI:

https://doi.org/10.29227/IM-2025-02-02-010

Keywords:

high-rise structures, seismic load, wind load, reinforced concrete frame, structural design, Eurocode

Abstract

In this work, reinforced concrete frame buildings (frame structures), with 5 to 30 floors were analyzed in order to determine how the dominant design load shift with increasing building height, The study focuses on the identification of the number of floors where the controlling variable load moves with the gravity-inducted (own and live) load on lateral forces (wind and seismic forces) and examines the implications of this shift on the dimensioning of structural elements. Using computer models in software ETABS/TOWER and applying EUROCODE standards (EN 1991 for permanent and EN 1992 for concrete design), a series of buildings with only a central reinforced concrete core (surrounding elevator shafts and staircases) and without additional shear walls was evaluated under combined load scenarios. The analysis identifies a critical building height (within 5- to 30-storey range) where loads begin to govern design, replacing gravity loads as the primary driver for column sizing and reinforcement requirements. The results show that below this threshold height, column design is determined by vertical loads, with cross-sectional requirements increasing towards the lower floors due to accumulated gravity loads. Above the threshold, in taller buildings, lateral displacement and stability requirements dominate the design. This change loads to a significant increase in the required column dimensions and reinforcement – especially in the lower floors – to meet the strength and stiffness criteria. The transition in dominant loading significantly affects the distribution of internal forces and the amount of reinforcement required along the height of the building. These findings highlight the importance of recognizing the height at which lateral loads become critical in the design process, as they implicitly affect material utilization and structural efficiency in frame structures of medium and high-rise buildings.

Author Biographies

  • Irhad Mrkonja

    1 * ) Department of Civil Engineering, Faculty of Engineering, Natural, and Medical Sciences, International Burch University, Francuske revolucije bb, 71210 Ilidža, Bosnia and Herzegovina , Irhad.mrkonja@ibu.edu.ba ; 0009 - 0005 - 5318 - 4469

  • Ahmed El Sayed

    2) Department of Civil Engineering, Faculty of Engineering, Natural, and Medical Sciences, International Burch University, Francuske revolucije bb, 71210 Ilidža, Bosnia and Herzegovina, Ahmed.elsayed@ibu.edu.ba ; 0000 - 0002 - 1668 - 8861

  • Sanin Džidić

    3) Department of Civil Engineering, Technical Faculty, University of Bihać, Irfana Ljubijankića bb 77000 Bihać, Bosnia and Herzegovina, ninsa_d@hotmail.com ; 0000 - 0002 - 8269 - 6667

Published

2025-11-05

Most read articles by the same author(s)