The Effects of Subgrade Soil Stabilization on Pavement Structural Design
DOI:
https://doi.org/10.29227/IM-2025-02-02-102Keywords:
California Bearing Ratio, Curing time, pavement design, subgrade soil, cement, stabilizationAbstract
This research work presents the effect of subgrade soil stabilization on pavement structural design through improving the engineering properties of weak subgrade soil by using Portland cement material. Soil samples were collected from three locations. Portland Cement material is selected in this study to stabilize the subgrade soils tack in consideration soil type and plasticity index. The California Bearing Ratio (CBR) test was performed on the laboratory-moulded stabilized and un-stabilized specimens in order to evaluate and compare the bearing capacity (is the capacity of soil to support the loads that are applied to the ground above) for each sample and the value of CBR before and after being stabilized. The soil and stabilizer (cement) were mixed with different percentages of cement to determine the optimum moisture content. Total of 45 CBR tests were performed taking into consideration 1-day and 7-day curing time to stabilize soil with cement. Outperforming results were observed for the increased added percentage of cement and in term the CBR value. Five percent cement was found to be the optimal mixing ratio and it demonstrated cost effective design. The results showed that the soil CBR values increased by approximately 60-70% at day 7 for this ratio. Furthermore, pavement design was conducted for un-stabilized and stabilized soils and the cost savings achieved from the stabilization was presented. The data showed that pavement design for stabilized soils achieved approximately 20-25% cost savings when compared with un-stabilized soils.
Downloads
Published
Issue
Section
License
Copyright (c) 2025 Ahmad M Shawashreh, Laith Tashman (Author)

This work is licensed under a Creative Commons Attribution 4.0 International License.